Standing seam and metal panel roofing, roof repair and full replacement in Klamath River. We show up when we say we will, and we clean up before we go.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Klamath River.
If wind got under your roof once it will try again. We fix the damage and close the edge back up so there is nothing left to catch.
Storm damage does not wait for business hours. We get the opening closed, photograph it for your insurance, and put the real fix on the schedule.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
Careful footwork, matched materials, and flashing done the way it was done when the roof went on.
If two other people have caulked it and it still leaks, call us. Most stubborn leaks turn out to be flashing, a valley, or a fastener nobody thought to check.
A metal roof is the one that outlives the mortgage. We install exposed fastener panels and standing seam over solid decking and real underlayment, with around twenty standard colors to choose from.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
Inspections come free with an estimate. We would rather find the small problem this spring than replace a ceiling for you next winter.
Coatings for low slope and older metal roofs that are still sound but weathered. Washed down, refastened, primed at the rust, then coated.
Guards and screens so you are not up a ladder every fall digging pine needles out of the gutter by hand.
A twenty year old panel roof usually needs fasteners and sealant, not replacement. We refasten with new washers and get you another long stretch out of it.
We still shingle plenty of roofs. Cracked, curled and blown off shingles get replaced, and the valleys and flashing get reworked while we are up there.
Most roofs somebody has called a lost cause are not one. We repair what can be repaired, and we tell you honestly when a repair will no longer hold.
Waterproofing details on additions, porches and low slope tie ins, where two roofs meet and most leaks quietly begin.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
Churches, shops, barns and small commercial buildings. We have roofed everything from a wood shed to a steeple.
New skylights set into metal or shingle roofs, with the flashing kit the roof actually calls for rather than a tube of sealant.
Removing the ice is the easy half. We also look at ventilation and insulation so it stops happening every January.
Repair or replace, we handle both, and we work from what the roof actually needs rather than from what an adjuster might approve.
Squirrels, wasps and water all treat a soft soffit as a front door. We close it up properly instead of patching over it.
Metal is what we are known for. Since 2002 the bulk of our work has been standing seam and metal panel roofs, and it is still what most Klamath River homeowners call us about. We measure on site, help you settle on a color, and set the panels straight.
We do shingle roofs too, and plenty of them. But if you have been thinking about a tin roof on your Klamath River home, that is the conversation we enjoy most — panel type, color, trim, and what it is really going to cost.
Here is what Klamath River homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Around twenty standard metal colors, and the chart comes out with the estimate so you can hold it up against your siding and shutters before you commit.
A few backed out screws or a whole roof off a church — we take both. No job is too small to get the same crew and the same care.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
The questions that come up on just about every estimate we write.
Sometimes. If the decking is sound and there is only one layer of shingles, a Klamath River metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
Most Klamath River houses are a two to four day job. A straightforward shingle roof can be done in a day or two. A cut up metal roof takes longer because every panel, valley and trim piece is measured and fit on site rather than pulled out of a box.
Often, yes. Plenty of the Klamath River roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
A metal roof installed properly on a Klamath River home should give you 40 to 60 years, and standing seam often goes longer because there are no exposed fasteners. Screws and sealants on a panel roof want attention around year 20, which is a small job next to a re-roof.
For most Klamath River homes, yes. A metal roof costs more up front than shingles, but it usually outlives two or three shingle roofs, sheds rain and snow better, and does not peel off in a hard wind. We will price metal and shingle side by side so you can compare real numbers instead of guessing.
Most Klamath River metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
Real feedback from homeowners whose roofs we have worked on.
"Tore off two layers of old shingles and found rotten decking underneath. They showed me the boards, told me what the change would cost, and let me decide before going ahead."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Honest people. I asked for a quote on a whole new roof and they told me mine had another eight years in it and just needed the valleys resealed. Who does that anymore?"
Our crews cover the surrounding area, not only the city limits.